Billet Aluminum Drag Link Support

These are the parts that nobody makes. This 6061-T6 Billet Drag Link Support enables the long steering shafts of today's 225" front engine dragster to be split into several pieces to enable good chassis flex and not have binding of the drag link. Also usable on altereds or funny cars where the rear link is fairly large to be strong enough and accommodate a bend to clear exhaust headers, but you do not want the weight of a large bar all the way forward. You can now split it for instance, at the front of the motor and run smaller pipe to the front. Or, to hold the shafts on a rack and pinion setup between u-joints.

These supports accommodate a 3/4" drag link and are available with notches to fit either 1 1/8" or 1 1/4" frame-rails. Sold with 4130 steel tabs for both sides, so it is in double shear, and grade 8 hardware.

Also available in Magnesium Kit for $40 ea.