9341 W. HWY K-31 BURLINGAME, KS 66413
Floater Rear End Housing - O-Ring Seal Floater Rear End Housing - with Spindles

Dragster & Altered Floater Rear End Housing

Spindles not included, starting at $1550.00 Call to order

Neil & Parks full floater housings are exceptionally and evolutionally different from the competition's housings. They start off with complete 100% 4130 Chrome Moly construction, a 1/4" faceplate, .090" rear structure, and 3/16 bulkheads. Our housing design eliminates the need for the tubes in which the spindles are typically welded into. By using special spindles we developed, we were able to eliminate that heavy tube, a 15-pound loss in itself. A typical complete weight is 43 pounds. Based on application, we can increase material thicknesses to deal with the additional stresses involved.

Just like our flange axle style housing, the thirdmember is sealed with an O-ring, no more gaskets or messy silicone for fast and easy gear changes.


  • Tumble finish available for housings 40" wide or less, $200 fee
  • Titanium version available, call for quote.
  • Brackets available at extra cost
  • Send your old rear end and we'll copy mounting points exactly. Bolt your new one in and go! Call for quote.
  • Available ready to race with your choice of gear set, bearings, axles, center chunk.
Material 4130 Chrome Moly (Titanium Optional)
Faceplate 1/4" Thick
Rear Structure .090" Thick